Exclusive representative of SIGNODE Industrial Group and Manuli Stretch.

Packin

Signode 4A1-114 Manual Steel Tensioner

The manual tensioners of SIGNODЕ, allow operators to tighten the strap to the desired tension with minimal effort and a waste of material.

Feedwheel tensioner for flat strapping

The feedwheel tensioner has a serrated feedwheel which grips the strapping firmly. There is no limit to length of the strap it can pull out and tighten. Fast and easy to use. To achieve the maximum effect, it requires the use of painted and waxed strip.

Shaft tensioners (flat strapping)

The tool allows the operator to tension the strap to the desired tension with minimal effort and a waste of material. The windlass tensioner simply winds one end of the strap around a slotted windlass shaft. Pre-cut steel strips are used which may not be waxed. This tensioner is especially suitable for heavy-duty applications.

Tensioner with feed wheel (round strapping)

This type of tensioner is used for small, round and irregularly shaped packages. The clamp is pulled over the strap. The collapsing edge of the tape is folded to 180 degrees. The strength of strapping is achieved by moving the tensioner towards the edge of the seal.

Toothed rod strap (round strapping)

The tensioning stroke is limited by the toothed bar and is approximately 220 mm. The tension can be repeated to achieve optimal strap strength. Strength of strapping is achieved by moving the tensioning horn.

Signode ST Manual Steel Tensioner

Signode T Manual Steel Tensioner

Signode TH Manual Steel Tensioner

Signode PF Manual Steel Tensioner

Signode PFH Manual Steel Tensioner

Signode PH-2 Manual Steel Tensioner